VEX

All Victor 883's use these fans to control heat dissipation. These small, high power muffin fans are a replacement for the fans on any Victor 883. Manufacturer: Comair - Rotron.IFIW-F12

The 954 cable is easiest way to connect to your microcontroller/Raspberry Pi/WiFi router serial console port or for programming your VEX Victor BB speed controller.Inside the big USB plug is a USBSerial conversion chip and at the end of the 36" cable are four wire - red power, black ground, white RX into USB port, and green TX out of the USB port. The power pin provides the 5V @ 500mA direct from the USB port and the RX/TX pins are 3.3V level for interfacing with the most common 3.3V logic...

The VEX Victor BB is designed from the ground up for Combat Robotics use. This is based on over 15 years of combat robot experience. VEX's goal was to produce the best performing, most durable, and light weight controller possible.Basic DesignUp to 12C (50v) battery inputestimated 300A continuousFan-lessSize is 3" x 3" x 1.5"Weight: 1.2 poundsThe entire outside of the product is an aluminum heat sink.Fully sealed8 AWG highly flexible wires for power and motorFEATURESPWM input. No signal...