• This Brushless Inrunner is what is used in the FingerTech Beater Bar Electronics. Its size and power make it ideal for beetleweight robot weapons (and aggressively ambitious for antweight weapons!)
• With an inrunner, you don't have to worry about wires getting caught by a spinning outer can.
Specifications:
RPM/V: 2970kv
Max Load: 22A
Max Volts: 14.8v 2s~4s
Max Watts: 300w
Resistance: 0.0500Ω
Weight: 98.71g
Motor Diameter: 28mm (1.10in)
Motor Length: 38mm (1.49in). 50mm (2.16in) to end of heatshrink.
Wire Length: 56mm (2.2in) (measured from end of heatshrink to end of bullet connector)
Mounting Holes: two M2.5 spaced 16mm (0.63in), two M3.0 spaced 19mm (0.75in)
-Do not use screws that protrude more than 4.7mm (0.18in) into the mounting face.
Shaft Diameter: 3.17mm (0.125in)
Shaft Length: 12.7mm (0.5in)
Can Size: 380
Plug Type: 3mm Bullet-connectors (inlcudes mating connectors for soldering on ESC)
Wiring: Connect the three ESC wires any way you like. If the motor is spinning backwards, swap any two wires.
0-FT-S2838-2970KV