48330 ESC Speed Control with Regenerative Braking

If you need to proporionally and remotely control a high current brushed motor, this is the ESC for you. They just don't get much more powerful than this.

This is the reversible speed control you need to run your Etek motor or PMG-132 motor properly. This control is a modified version of the standard Sevcon. It comes with the RCA Analog Interface.

Voltage Input: 14.5 to 58 VDC
Maximum Current: 330 A
Interface: Direct to receiver with Futaba J connector
Weight: 6.3 lbs
Construction: Rugged aluminum case, with interface board.
Width: 5.71"
Length: 7.48"
Height:
2.05" case, 2.64" terminals

RCA Analog Interface

Use this board to interface between your receiver and large speed controls that are not already set up for radio-controlled operation.

(Not needed if you already have the above 48330 controller with interface)

* The board closes a forward and reverse circuit
* The board provides a 0-5K variable resistance
* Ships with a Futaba J Cable installed

 


48330 Calibrator

Allows you to change Parameters on the 48330 ESC Speed Control

Programmable Parameters:
- Current Limit
- Regen Braking
- Acceleration Delay
- Deceleration Delay
- Maximum Speed
- Acceleration Curve Typ